← World 10: IV Access & Contrast

Learning module

💉 IV Start Module

Peripheral IV insertion and contrast administration for imaging technologists — devices, veins, site selection, asepsis, insertion, contrast safety, complications and removal.

This module does not authorize you to start IVs.

It supports the theory portion of an employer's venipuncture authorization program. Authorization requires your organization's program and policies, a supervised hands-on skills assessment by an authorized assessor (often several observed successful insertions), and any requirements of your regulator. Local policy and product instructions always take precedence.

Learn

Untimed questions with full explanations.

Practice

Mixed questions from the 65-question bank.

Exam

Timed. Aim for 80% — the pass mark many authorization programs use.

Vein Picker

Choose the arm, the site and the catheter gauge for each patient.

IV Steps

Put preparation, insertion, finishing and removal steps in order.

Case: Contrast Checkpoint

Kidney function, then a swollen arm during injection.

Lessons

1. Purpose, devices and catheter size
  • In imaging, IV access is for giving ordered contrast and saline — and it provides access if a reaction or emergency happens.
  • Smaller gauge number = bigger catheter. Choose the smallest catheter that delivers the flow rate the exam needs.
  • Typical choices: 22–24 G for routine exams and small or difficult veins; 20–18 G for fast-bolus studies such as MR angiography, dynamic abdominal MRI and perfusion.
  • Power injection needs a flexible catheter rated for the planned pressure and flow. Steel butterfly needles aren't used, and 24 G catheters aren't recommended with pressure injectors.
  • Central lines are power injected only if they're power-rated, and only by staff certified for it under local policy.

⚠️ Catheter gauge, pressure ratings and flow-rate limits are set by your site protocol and the device labeling.

2. Arteries, veins and the upper-limb vein map
  • Veins: superficial, no pulse, thin walls, valves. Arteries: deeper, pulsatile, bright red pressurized blood.
  • Cephalic vein — thumb (radial) side of the forearm. Basilic vein — little-finger (ulnar) side. Median cubital vein — front of the elbow, joining the two.
  • Dorsal hand (metacarpal) veins are visible and accessible but small and fragile — not suited to high flow rates.
  • The brachial artery and median nerve lie deeper in the antecubital fossa; the radial artery and nerves are close to the surface at the inner wrist.

⚠️ Palpate before inserting. Never cannulate a vessel you can feel pulsing.

3. Choosing the site
  • Start with the most distal suitable site and work upwards, so a failed attempt doesn't spoil the vein above it.
  • For power injection, a large antecubital or forearm vein is usually the first choice.
  • Avoid: an arm with a dialysis fistula or graft; infected, injured or inflamed skin; sites below a recent failed attempt or bruise; the inner (volar) wrist.
  • The arm on the side of axillary node removal or with lymphedema is traditionally avoided — follow local policy.
  • Dilation tips: let the arm hang down, apply the tourniquet, use warmth, and ask the patient to open and close their hand gently.

📌 Current standards: Current INS standards recommend vein visualization technology, such as ultrasound guidance, for patients with difficult venous access — check whether your site offers it and who may use it.

4. Preparing: checks, hygiene and antisepsis
  • Confirm the order. Identify the patient with two identifiers. Screen for allergies, prior reactions, relevant medications and kidney function as your protocol requires. Explain and obtain consent.
  • Gather supplies: catheter, extension set, saline flush, tourniquet, antiseptic, dressing and securement, labels, PPE, and a sharps container within reach.
  • Perform hand hygiene, put on gloves, inspect the equipment and prime the tubing so no air remains.
  • Trim hair with clippers or scissors if needed — never shave and never use depilatory cream.
  • Clean with alcoholic chlorhexidine (e.g. 2% CHG / 70% alcohol): back-and-forth friction for about 30 seconds, an area larger than the dressing, then let it dry completely. Wash visibly dirty skin first.
  • If you must palpate again, avoid the cleaned insertion point — or re-clean.

📌 Current standards: Current guidance favors single-patient-use tourniquets. Apply just before insertion and release promptly.

5. Inserting an over-the-needle catheter
  • Sit if possible, with an absorbent pad under the arm. Check the stylet and catheter are intact.
  • Anchor the vein below the site with your non-dominant thumb, keeping the skin taut.
  • Insert bevel up at a low angle. Watch for flashback, then lower the angle almost parallel to the skin and advance slightly.
  • Advance the catheter off the stylet into the vein. Release the tourniquet, occlude the vein above the tip if your device needs it, and activate the safety feature as you withdraw the stylet.
  • Put the stylet straight into the sharps container — never recap it or set it down.
  • Connect the primed extension set, flush to confirm free flow with no pain or swelling, then secure with a sterile transparent dressing and label it.

⚠️ If the stylet comes out early, NEVER push it back in — it can shear the catheter and cause an embolus.

📌 Current standards: Attempt limits: current INS standards allow no more than 2 attempts per clinician and no more than 4 in total. Escalate to a more skilled clinician or an alternative (e.g. ultrasound-guided insertion) — and ask for help sooner if you predict difficult access.

6. Documentation
  • Date and time; site; catheter gauge and length; number and locations of attempts.
  • Contrast agent and amount; how the patient tolerated it; any difficulties; whether an infusion pump or injector was used; saline lock if applicable.
  • Patient teaching given; your signature and designation.
  • Report hazards, close calls and adverse events through your organization's safety reporting system.
7. Giving contrast safely
  • Use the rights of medication administration: right patient, medication, dose, time, route, reason and documentation — and respect the patient's right to refuse.
  • Check the contrast label twice. Never use an unlabeled syringe or container. Keep the container until the patient leaves the department.
  • Before power injection: confirm patency with saline, check the catheter rating, and warm contrast per the manufacturer to lower viscosity.
  • Watch or check the site as the injection starts, and stop immediately if swelling or pain appears.
  • In MRI the arm is in the bore: test the line with saline before the table moves in, use an MR Conditional injector positioned as labeled, and coach the patient to press the call bell at once if anything hurts.

📌 Current standards: ACR: metformin doesn't need to be stopped for standard-dose gadolinium. The 48-hour hold applies to iodinated contrast when eGFR is below 30 or there is acute kidney injury. For Group II gadolinium agents, ACR considers kidney-function screening optional — follow your site policy.

8. Complications and contrast reactions
  • Infiltration / extravasation: stop the injection, elevate the limb, notify the radiologist, use compresses per policy, document and arrange follow-up. Escalate urgently for progressive swelling or pain, blistering, or reduced circulation or sensation.
  • Phlebitis (redness, warmth, pain along the vein): remove the catheter and document.
  • Hematoma or arterial puncture: remove, apply firm prolonged pressure, check the limb, report.
  • Mild reactions (limited hives, itching, nausea): keep IV access, inform the radiologist, observe — generally at least 30 minutes. Moderate or severe reactions follow the site's reaction protocol, with the reaction kit and emergency team.
  • Risk factors include a prior reaction to the same contrast class, asthma and multiple allergies. Shellfish allergy has no specific link to contrast reactions.
  • Know where the reaction kit is, how to call for help, and that emergencies in MRI are managed outside Zone IV.

📌 Current standards: Terminology has moved from “contrast-induced nephropathy” to contrast-associated acute kidney injury (CA-AKI). The ACR–NKF consensus (2020) found the risk from IV contrast is lower than once thought. Treatment details (drugs and doses) are set by your reaction protocol, not by this module.

9. Removal and patient teaching
  • Remove IVs that are no longer needed — outpatients before they leave, unless there's a documented reason (e.g. observation after a reaction).
  • Hand hygiene and gloves; stop any infusion; remove the dressing carefully; withdraw the catheter gently.
  • Apply pressure with gauze until bleeding stops (longer with anticoagulants), check the catheter tip is intact, then cover the site.
  • Teach: contrast injections should not hurt — report pain, swelling, burning, numbness or hot/cold sensations. After removal, seek advice for swelling, redness, pain or bleeding.

Practice checklist

For simulation and self-review. Your organization's signed skills checklist is the official record.

  1. Confirm the order for the contrast examination
  2. Identify the patient with two identifiers
  3. Screen for contraindications (allergies, prior reactions, medications, kidney function as required)
  4. Explain the procedure and obtain consent
  5. Choose the catheter gauge and length and gather supplies
  6. Perform hand hygiene and put on gloves
  7. Inspect equipment and prime the extension set (no air)
  8. Apply the tourniquet and select the vein using dilation techniques
  9. Clean the site with friction and let it dry completely
  10. Avoid touching the insertion point if palpating again
  11. Anchor the vein and stabilize the skin
  12. Insert bevel up at a low angle; lower the angle after flashback and advance slightly
  13. Advance the catheter off the stylet into the vein
  14. Release the tourniquet
  15. Occlude above the tip if required and activate the safety feature as the stylet is withdrawn
  16. Dispose of the stylet in the sharps container immediately
  17. Connect the primed extension set and flush — check for pain or swelling
  18. Apply a sterile transparent dressing, secure and label it
  19. Remove gloves, dispose of items and perform hand hygiene
  20. Teach the patient what to report
  21. Document the insertion details

Renewal self-check

If any of these isn't true for you, review your technique with an educator or supervisor.

  • ☐ I rarely miss a venipuncture.
  • ☐ Patients don't usually report discomfort when I start an IV.
  • ☐ I can attempt and complete difficult venipunctures — and I know when to ask for help.
  • ☐ I notice when equipment or the site might become contaminated.
  • ☐ I consistently complete every step of the checklist.